albertareef Posted October 29, 2018 Share Posted October 29, 2018 33 minutes ago, kjlife said: Set up this way makes sense now thanks so much o couldn't seem to figure this sump out lol thanks again No worries - good luck! Quote Link to comment Share on other sites More sharing options...
kjlife Posted October 30, 2018 Author Share Posted October 30, 2018 Yea just to decide weather I'm sticking with this light and getting it inside and full of salt lol Quote Link to comment Share on other sites More sharing options...
kjlife Posted October 31, 2018 Author Share Posted October 31, 2018 Incase anyone curious test full complete everything running and work probably looking at a return pump upgrade and I own a AI prime already so I'll probably end up buying another and losing the th5 mh combo 1 Quote Link to comment Share on other sites More sharing options...
dynellep Posted October 31, 2018 Share Posted October 31, 2018 On 10/24/2018 at 7:34 PM, kjlife said: Barbed fitting are good for low psi settings. Flow only plays a small factor. If it's not barbed ensure you use hose clamps and do not overtighten. You'll know by the water creep near the connection. Treat it just like an oring, too much pressure is the same as too little. It's hard to be exact because marine application do not provide torque settings due to unkown flow paths. 1 Quote Link to comment Share on other sites More sharing options...
kjlife Posted October 31, 2018 Author Share Posted October 31, 2018 Yea I'm currently looking into another return pump Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.